Braemar ECOSTAR - Fault messages and Troubleshooting

Fault messages
Seeley International Pty Ltd has a policy of continuous product development and therefore reserves the right to make
changes to these specifications without notice. Whilst every care has been taken to assure the accuracy of the data
compiled in this document, Seeley International does not assume any liability for errors and/or omissions.
Manual part No: 634443-B
Braemar is a registered trademark of Braemar Industries Pty Ltd.
Seeley International Pty Ltd ACN 23 054 687 035
Albury manufacturing plant
77 North Street Albury, NSW 2640
Your Braemar Ecostar Space Heater uses inbuilt fault diagnosis software to
help determine the source of a fault. If the heater detects a fault the heater will
turn off and the remote control will flash RESET and a fault code (FC). The
control panel indicators on the front of the heater will also flash to indicate the
fault code. Please quote this fault code if requesting a service call - this may
enable the problem to be fixed over the phone.
FC Potential remedy
1 Press RESET on remote control.
2
5
7
9
10
11
12
13
15
19
Check flue terminal is not obstructed. Press RESET on remote
control.
Service call.
Check gas is turned on. Press RESET on remote control.
Service call.
Check inlet and outlet louvres are not obstructed. Press
RESET on remote control.
User reset.
User reset.
Check flue terminal is not obstructed. Press RESET on remote
control.
Check inlet and outlet louvres are not obstructed. Press
RESET on remote control.
Service call.
If a fault is repeated after a USER RESET or after switching the
power to the heater off and back on a service call may be required.
For Service call 1300 650 644, or contact your local Braemar dealer.
In the event of a power failure the heater will shut down. A manual
re-start will be required after restoration of the power supply.