BRASS MONKEY GH2020 - Troubleshooting; Refrigerator does not work; Refrigerator compartments are too warm; Food is frozen

12
TROUBLESHOOTING
ISSUE SUGGESTED REMEDY
Refrigerator does not work • Check if the switch is on.
• Check if the plug and socket are connected well.
• Check if the fuse has been burnt.
• Check if the power supply is malfunctioned.
• Switch on/o the fridge frequently may cause start delay of
the compressor
Refrigerator compartments
are too warm
• The lid is opened frequently.
• A large amount of warm or hot food was stored recently.
• The refrigerator has been disconnected for a long time.
Food is frozen The temperature was set too low
There is “water flow” noise
from inside the refrigerator
It’s a normal phenomenon, caused by the flow of refrigerant.
There are waterdrops
around the refrigerator
casing or door gap
It’s a normal phenomenon, the moisture will condense to water
when it touches a cold surface of the refrigerator.
The compressor is slightly
noisy when starting
It’s a normal phenomenon, the noise will be reduced
after the compressor works stably.
Code F1 displayed Possible cause: low voltage to fridge.
Adjust the battery protection from High to Medium or from
Medium to Low.
Code F2 displayed Possible cause: condenser fan is overloaded.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
Code F3 displayed Possible cause: the compressor starts too frequently.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
Code F4 displayed Possible cause: compressor not kicking in.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service
Code F5 displayed Possible cause: overheating of the compressor & electronics.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
Code F6 displayed Possible cause: no parameter can be detected by the controller.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
Code F7 or F8 displayed Possible cause: temperature sensor is faulty.
Contact manufacturer for service.