To Next PageTo Next PageWhat to do if my Braun Electric Shaver turns off with a fully charged battery?
If your shaver turns off even with a fully charged battery, the foil and cutter may be worn, demanding more power than the motor can provide. To fix this, renew the Foil & Cutter cassette and regularly oil the shaving system, especially if you clean it with water alone.
What to do if battery segments in the display are skipped with decreasing battery capacity in Braun Rechargeable shaver?
If the battery segments in your Braun Rechargeable shaver's display are skipped as the battery capacity decreases, it's likely because the foil and cutter are worn, requiring more power for each shave. To resolve this, renew the Foil & Cutter cassette and regularly oil the shaving system, particularly if you clean it with water only.
Why has the battery performance of my Braun Rechargeable shaver dropped significantly?
If you notice a significant drop in your Braun Rechargeable shaver's battery performance, it could be due to a couple of reasons: worn foil and cutter, which demand more power for each shave, or regular cleaning with water without proper lubrication. Consider renewing the Foil & Cutter cassette. If you regularly clean the shaver with water, apply a drop of light machine oil on top of the foil once a week to lubricate it.
Why is my Braun Electric Shaver cleaning fluid consumption increased?
Increased cleaning fluid consumption in your Braun Electric Shaver's Clean&Renew station is often due to a clogged drain. Try cleaning the drain with a wooden toothpick and regularly wipe the tub clean.
What to do if my Braun 7898cc head is damp?
A damp shaver head on your Braun Electric Shaver can occur for a few reasons: * Insufficient drying time after automatic cleaning. Try cleaning directly after shaving to allow more drying time. * A clogged Clean&Renew station drain. Clean the drain with a wooden toothpick and regularly wipe the tub clean. * Prolonged use of the cleaning cartridge. The ethanol/isopropanol proportion decreases while the oil proportion increases. Remove residue with a cloth.
Why is the shaver head of my Braun Electric Shaver damp?
A damp shaver head can result from a few issues: 1. The drying time after automatic cleaning might be too short. Try cleaning directly after shaving to allow ample drying time. 2. The Clean&Renew station's drain could be clogged. Clean it with a wooden toothpick and regularly wipe the tub clean. 3. The cleaning cartridge might have been used for too long, decreasing the ethanol/isopropanol proportion while increasing the oil proportion. Remove any residue with a cloth.
Why is there increased consumption of cleaning fluid in my Braun 7898cc Electric Shaver's cleaning station?
Increased consumption of cleaning fluid in your Clean&Renew station is often due to a clogged drain. Clean the drain with a wooden toothpick and regularly wipe the tub clean to resolve this issue.
What to do if cleaning does not start when pressing the start button on my Braun Electric Shaver?
If the cleaning cycle doesn't start when you press the start button on your Braun Electric Shaver, consider these possibilities: * The shaver might not be properly placed in the Clean&Renew station. Ensure the shaver's contacts align with the station's contacts. * The cleaning cartridge may not contain enough cleaning fluid. If the display lights red, insert a new cleaning cartridge. * The appliance could be in stand-by mode. Press the start button again.
What to do if the cleaning cycle does not start when pressing the start button on my Braun Electric Shaver?
If cleaning doesn't start when you press the start button, check the following: 1. Ensure the shaver is correctly placed in the Clean&Renew station, with the shaver's contacts aligned with those in the station. 2. Verify that the cleaning cartridge has enough cleaning fluid (the display will light red if it doesn't). If needed, insert a new cleaning cartridge. 3. Make sure the appliance is not in stand-by mode. If it is, press the start button again.
General| Brand | Braun |
|---|---|
| Model | 7898cc |
| Category | Electric Shaver |
| Language | English |
Instructions for setting up the Clean&Renew station, including cartridge installation and power connection.
Procedure for inserting the shaver into the station for charging and automatic cleaning analysis.
Instructions on operating the shaver, adjusting the head, and trimming.
Procedure for automatic cleaning after each shave using the Clean&Renew station.
Instructions for cleaning the shaver head under running water or with a brush.
Steps for safely removing and replacing the cleaning fluid cartridge.
Instructions for replacing shaver parts and resetting maintenance indicators.
