Braun 7898cc - User Manual

Other manuals for Braun 7898cc

Questions and Answers:

H
Haley PerezAug 27, 2025
Why is the shaver head of my Braun Electric Shaver damp?
- E
  Eric LutzAug 27, 2025
  A damp shaver head can result from a few issues: 1. The drying time after automatic cleaning might be too short. Try cleaning directly after shaving to allow ample drying time. 2. The Clean&Renew station's drain could be clogged. Clean it with a wooden toothpick and regularly wipe the tub clean. 3. The cleaning cartridge might have been used for too long, decreasing the ethanol/isopropanol proportion while increasing the oil proportion. Remove any residue with a cloth.
J
Joel JohnsonAug 27, 2025
Why is there increased consumption of cleaning fluid in my Braun 7898cc Electric Shaver's cleaning station?
- L
  Laura WrightAug 27, 2025
  Increased consumption of cleaning fluid in your Clean&Renew station is often due to a clogged drain. Clean the drain with a wooden toothpick and regularly wipe the tub clean to resolve this issue.
N
Nicholas SalinasAug 25, 2025
What to do if cleaning does not start when pressing the start button on my Braun Electric Shaver?
- S
  stephaniejamesAug 26, 2025
  If the cleaning cycle doesn't start when you press the start button on your Braun Electric Shaver, consider these possibilities: * The shaver might not be properly placed in the Clean&Renew station. Ensure the shaver's contacts align with the station's contacts. * The cleaning cartridge may not contain enough cleaning fluid. If the display lights red, insert a new cleaning cartridge. * The appliance could be in stand-by mode. Press the start button again.
M
Martin StewartAug 25, 2025
What to do if the cleaning cycle does not start when pressing the start button on my Braun Electric Shaver?
- G
  Gabriel VaughnAug 25, 2025
  If cleaning doesn't start when you press the start button, check the following: 1. Ensure the shaver is correctly placed in the Clean&Renew station, with the shaver's contacts aligned with those in the station. 2. Verify that the cleaning cartridge has enough cleaning fluid (the display will light red if it doesn't). If needed, insert a new cleaning cartridge. 3. Make sure the appliance is not in stand-by mode. If it is, press the start button again.