Braun CareStyle 7 Pro - Advanced Features and Ergonomics; Vertical Steam Application; Ergonomic Design and Usage Tips; Auto Shut-off and Descaling Guide

10
Vertical steam
The iron can also be used for steaming han-
ging clothes. Hold the iron in a vertical posi-
tion and select ProSteam
setting.
Caution: steam is very hot. Never iron or
dampen garment while wearing them.
Ergonomic certification
This unit, assessed and certified by an Er-
gonomics Certifying Institute has been er-
gonomically designed, for eortless ironing
and excellent results fulfilling the ergonomic
requirements belonging to Polytechnical,
Biomedical, Psychosocial (usability) and
Human Centered Design Process area.
Real users have been actively involved in all
phases of product design and in testing pro-
cess to get a more satisfying experience.
Follow the below recommendations, for an
eortless and more comfortable ironing ex-
perience:
z
Before starting your ironing session, it is
recommendable to self-adjust your ironing
board in order to reduce shoulders bad
postures. The ideal position should allow
a 90° angle for your elbow so that your
shoulders and back can freely move.
z
In addition, for extra comfort and
convenience during storage and
transportation, wrap the power cord
around your hand before storing it inside
the machine securely, then block it with
the provided clip.
z
It is recommendable emptying the water
tank before transporting the unit and
making sure not to overly bend your back
while lifting it.
(E) Auto Off
This function is activated if after 10 minutes
there has been no steam emission.
z
When the iron is in the auto-o mode, the
On/O button (1) and the icon related to
the selected setting start flashing.
z
To continue ironing, press any button and
wait until the related icon for the setting is
permanently on.
z
After additional 10 minutes without steam
emission, the iron and the steam station
turn o.
(F) Descaling
Never open or touch the closure (10) when
the appliance is hot and/or plugged in.
Do not use any chemicals, additives or de-
scaler to rinse the boiler.
When the system needs to be decalcified the
FastClean icon (3) turns permanently on.
To perform the descaling take the following
steps:
z
Switch o (1) and unplug the appliance.
z
Empty the water tank.
z
Wait until the appliance has cooled down
(minimum 2.5 hours).
z
Place the appliance on the edge of the sink
and turn the closure (10) anticlockwise to
open it. Let the water flow into the sink.
z
Clean the closure under running water to
remove the scale formations.
z
When no more water comes out of the
appliance screw the closure clockwise to
close the boiler.
z
Plug in and switch on.
z
Press the FastClean system button (3) for
2 seconds to reset.
If the appliance is switched o without de-
scaling, the FastClean icon (3) turns per-
manently on again when it is next switched
on.
Note: Because of the dierent water com-
position by using an installed in-house
permanent descaler, it is recommended to
descale the system after every 4 complete
refills or at least once per month.
Please note that in this case the FastClean
icon will not automatically turn on.
5712870073_IS72xx_INT.indd 105712870073_IS72xx_INT.indd 10 15.07.22 11:1315.07.22 11:13