Braun CareStyle 7 Pro - Post-Ironing Care and Storage; Cleaning and Maintenance Steps; Lock System and Transportation

11
(G) After ironing
Care & Cleaning
After every ironing session remove and
empty the water tank.
z
Before cleaning, always make sure that
the appliance is switched o, unplugged
and has cooled down completely.
z
To clean the soleplate and the soft
material on the handle it is suggested to
use a damp cloth.
z
Never use chemicals, vinegar or scouring
pads (eg. sponges with coarse nylon
fabrics etc).
Lock system
The appliance is equipped with a lock sys-
tem for convenient transportation and easy
storage. It is possible to lift and carry the ap-
pliance on the handle of the locked iron.
Note: Before transportation make sure the
iron is properly locked and the water tank is
empty.
z
Place the soleplate into the recess on the
iron mat.
z
To lock the iron push the slider (8) (easy
lock) toward the iron until you hear a
“click”.
z
To unlock the iron push down the button
on the slider (easy lock). The iron will be
released.
Storage
Unplug, empty the water tank and let the ap-
pliance cool down before winding the cords
for storage.
For a convenient storage of the power cord
also refer to „Ergonomic Certification“.
Troubleshooting Guide
Problem
Cause Solution
The appliance does
not switch on.
The appliance is not
plugged into a mains
socket.
Make sure the appliance is cor-
rectly connected and press the
On/O button.
Steam comes out
under the base unit.
The “max” pressure safety
system has opened.
Turn the appliance off immedi-
ately and contact an authorised
Braun Customer Service.
There are some water
drops from the holes
in the bottom of the
soleplate.
Water has condensed
inside the tubes because
steam is being used for the
first time, or has not been
used for some time.
Press the steam button sever-
al times away from the ironing
board. This will eliminate cold
water from the steam circuit.
Brown coloured fluid
leaks from the sole-
plate.
Chemical water softeners or
additives have been poured
into the water tank.
Never pour products into the water
tank. Clean the soleplate with a
damp cloth and rinse the boiler.
The first time the
appliance is turned
on, you notice smoke
or smell.
Some parts have been
treated with sealer/lubri-
cant which evaporates the
first time the iron heats up.
This is normal and will stop when
you have used the iron a few times.
If the smoke/smell is still present
after turning off the appliance, con-
tact an authorised Braun Customer
Service.
5712870073_IS72xx_INT.indd 115712870073_IS72xx_INT.indd 11 15.07.22 11:1315.07.22 11:13