EasyManuals Logo
Home>Braun>Thermometer>NTF 3000

Braun NTF 3000 Owner's Manual

Braun NTF 3000
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
12
English
13
Errors and troubleshooting
Situation
When 20% of battery life
is left, the display flashes
the low battery warning
symbol, however, the
device can still work until
the battery life has 0% left.
If the steady battery icon is
the only symbol shown on
the display, the device
cannot work. The battery
should be replaced
immediately.
This message displays
when measured
temperature is lower than
34.4°C (93.9°F ) or higher
than 42.2°C (108°F ) or
when the room temperature
is outside the operating
range of 15°C-40°C
(59°F-104°F )
Blank display.
Thermometer
does not have power.
Contact customer service if
thermometer still does not
function.
Error Message Solution
Replace battery.
Replace battery.
Make sure the protective
cap is removed.
Re-measure the
temperature again,
carefully following the
instruction in “How to
use” section.
Please check if the
battery has been loaded
correctly. Also check
polarity (<+> and <–>) of
batteries.
Care and cleaning
The thermometer should be cleaned in between uses, as necessary. Use an
alcohol swab or cotton swab moistened with alcohol (70% Isopropyl) to
clean the thermometer casing and the measuring probe. Ensure that no
liquid enters the interior of the thermometer. Never use abrasive cleaning
agents, thinners or benzene for cleaning and never immerse the instrument
in water or other cleaning liquids. Wait 10 minutes after cleaning before
taking a temperature measurement. Make sure to replace the protective
cap after use to prevent scratches or damage from occurring to the
thermometer.
Never insert a sharp object into the scanner area or any other open surface
on the thermometer.
Replacing the batteries
The Braun No touch + forehead thermometer comes with 2 AA batteries.
Replace with 2 new AA batteries when the steady battery symbol appears
on the LCD display. To change the batteries, slide open the battery cover
and remove batteries. Replace the batteries being sure to align properly as
indicated inside the battery compartment. Remove the battery from the
product if it is not required for extended periods of time in order to avoid
damage to the thermometer resulting from a leaking battery.
To protect the environment, dispose of device and empty batteries at
appropriate collection sites according to national or local regulations.

Other manuals for Braun NTF 3000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Braun NTF 3000 and is the answer not in the manual?

Braun NTF 3000 Specifications

General IconGeneral
BrandBraun
ModelNTF 3000
CategoryThermometer
LanguageEnglish

Related product manuals