Breville Oracle User Manual

39
PROBLEM EASY SOLUTION WHAT TO DO
Water does not flow
from the group head
•
Machine has not
reached operating
temperature.
•
Allow time for the machine to reach operating
temperature. The POWER button will stop
flashing when machine is ready.
•
Water
tank is empty.
•
Fill tank. Prime the system by:
•
1) Pressing 2 CUP button to run water through
the group head for
30 seconds.
•
2) Pressing HOT WATER button to run water
through the hot water outlet for 30 seconds.
•
Water tank
not fully
inserted & locked.
•
Push water tank in fully and lock latch closed.
FILL TANK on LCD
but water tank is full
•
Water tank
not fully
inserted & locked.
•
Push water tank in fully and lock latch closed.
No hot water
•
Water
tank is empty.
•
Fill water tank.
No steam
•
Steam
wand is blocked.
•
Refer to 'Cleaning the Steam Wand', page 33.
The machine is ‘On’
but ceases to operate
•
Turn machine off. Wait for 60 minutes and turn
machine back on.
•
If problem persists, call Breville
Consumer Support.
Steam pouring out
of group head
•
Turn machine off. Wait for 60 minutes and turn
machine back on.
•
If problem persists, call Breville
Consumer Support.
Espresso only drips
from the portafilter
spouts, restricted flow
•
Coffee is ground
too finely.
•
Adjust the grind size to a higher number to make
the grind size slightly coarser.
Espresso flows out
too quickly
•
The
coffee is ground
too coarsely.
•
Coffee
beans are stale.
•
Adjust the grind size
to a lower number to make the grind size
slightly finer.
•
Use freshly roasted coffee beans with a 'Roasted
On' date and consume between 5-20 days
after that date.

Breville Oracle Specifications

General

Water Tank Capacity	84 oz
Pump Pressure	15 bar
Material	Stainless Steel
Bean Hopper Capacity	0.5 lb
Color	Stainless Steel