BRIGHT 025972 - Use; To Do Before Use; Status Light; Charging

EN
27
– Arrow button left: In standby or run
mode, press this button to turn the
vacuum cleaner to the left.
– Arrow button right: In standby or run
mode, press this button to turn the
vacuum cleaner to the right.
FIG. 2
USE
TO DO BEFORE USE
• Remove fragile objects, cords, clothing,
and paper. Fold up curtains and drapes
that the vacuum cleaner might get caught
in.
• Roll up the edges of carpets, or only use
the vacuum cleaner on short-pile carpets.
• Arrange furniture so that the vacuum
cleaner cannot get stuck.
• Remove cords and objects from the oor.
• Use a fall protection device to ensure that
the vacuum cleaner does not fall down
stairs.
• Check that the dust container is empty
before starting the vacuum cleaner.
• Charge the vacuum cleaner for 6 hours
before using it for the rst time.
STATUS LIGHT
Start button and status light:
– Press down: Start (o mode)
– Press down: Switching o (run
mode)
– White ashing light: Standby mode
– White constant light: Run mode
– White, rapidly ashing light: Charging
– O: Fully charged
CHARGING
At low battery charge level, the start and stop
buttons light up red and an audio prompt is
given for two minutes.
During ongoing charging, the start and stop
buttons ash rapidly in white.
When the battery is fully charged, the start and
stop buttons go o.
1. Switch o the power switch on the
vacuum cleaner.
2. Plug the mains adapter into a power point
with the correct voltage.
3. Connect the mains adapter cord to the
charging port on the vacuum cleaner.
NOTE:
• Switch o the vacuum cleaner with the
power switch when is not going to be
used.
• Do not use the vacuum cleaner when
charging is in progress.
IMPORTANT:
• Charge the vacuum cleaner for at least 6
hours before using it for the rst time.
• Fully charge the battery after use.
• For optimal battery life span, the battery
should be charged every other month if
the vacuum cleaner is not being used.
STARTING
/
STOPPING
Press the start button one second. The start
button lights up, and the vacuum cleaner
starts. Press the button for three seconds to
switch o the vacuum cleaner.
NOTE:
The vacuum cleaner switches o
automatically after ve minutes of no
activity.
VACUUM CLEANING MODES
All vacuuming modes can be interrupted with
the start button on the vacuum cleaner or on
the remote control. The vacuum cleaner can
automatically switch to a dierent vacuuming
mode than the one selected manually, if it
proves to provide better vacuuming results in
the actual conditions.