BRIGHT 025972 - Replacing the Battery; Vacuum Cleaner Battery Replacement; Remote Control Battery Replacement

EN
29
Remove the cleaning cloth, rinse it, and let it
dry at before putting it back in place.
NOTE:
Do not put the cleaning cloth back when it
is still soaking wet as it may pose a slipping
risk.
CLEANING THE SENSOR WINDOW
Carefully clean the vacuum cleaner’s sensor
window with the cleaning tool or a soft cloth.
REPLACING THE BATTERY
Vacuum cleaner
1. Switch o the power switch on top of the
vacuum cleaner.
2. Loosen the screws (A) holding the battery
cover in place on the underside of the
vacuum cleaner.
FIG. 5
3. Remove the battery cover and take out
the battery.
4. Gently press the battery holder release
to detach the battery from the vacuum
cleaner.
FIG. 6
FIG. 7
5. Put the new battery in the battery
compartment with the text side facing up.
6. Place the wires next to the battery and
replace the battery cover.
7. Start the vacuum cleaner and check that
it is working properly.
NOTE:
• Only use batteries of the type
recommended by the manufacturer.
• Charge the new battery for at least six
hours before using it for the rst time.
Remote control
1. Open the battery cover on the back of the
remote control.
2. Put the batteries in the remote control.
3. Close the battery cover on the back of the
remote control.
NOTE:
• Remove the batteries if the remote
control is not going to be used for some
time.
• Do not mix old and new batteries, or
dierent types of batteries.