BRIGHT 025972 - Maintenance; Cleaning the Side Brushes; Cleaning the Dust Container and Filter; Cleaning of Cloth

EN
28
Automatic vacuum cleaning
In run mode, press the "Auto" button on the
remote control to start scheduled automatic
vacuuming.
Focused vacuum cleaning
Place the vacuum cleaner next to the area to
be vacuumed and press the "Focus" button on
the remote control to start focused vacuuming.
Random vacuum cleaning
In standby mode, press the "Start" button on
the remote control or on the vacuum cleaner
to start random vacuuming. In run mode, press
the "Random" button on the remote control to
start random vacuuming.
FITTING THE CLEANING CLOTH
1. Press the cleaning cloth rmly and evenly
onto the underside of the accessory plate
(the cloth can be damp).
2. Hang the accessory plate with the
attached cleaning cloth on the underside
of the vacuum cleaner in the direction
of the arrow and t both tabs of the
accessory plate into the holes underneath
the vacuum cleaner.
FIG. 3
IMPORTANT:
The capacity of the vacuum cleaner to
navigate inclined surfaces can be aected
when using the cleaning cloth and accessory
plate.
MAINTENANCE
CLEANING THE SIDE BRUSHES
If necessary, clean the side brushes with water.
Allow to dry completely before retting them.
Replace the side brushes if they become
damaged or are not working properly.
NOTE:
Place the side brush marked L on the left-
hand side, and the side brush marked R on
the right-hand side of the vacuum cleaner.
CLEANING THE DUST CONTAINER
AND FILTER
Empty and clean the dust container after use.
1. Open the foldable lid and remove the dust
container.
2. Remove the dustbin.
3. Check that the suction channel is not
blocked by any foreign objects. Clear the
suction channel, if necessary. Remove the
primary lter and HEPA lter.
4. Clean the dust container, primary lter
and the HEPA lter carefully. Clean the
primary lter every 15 to 30 days and
replace the HEPA lter after every 150
hours of operation.
5. Fit all parts correctly before starting the
vacuum cleaner. Never use the vacuum
cleaner without the HEPA lter and
primary lter in place, this can damage
the vacuum cleaner.
FIG. 4
NOTE:
• Clean all the parts and allow to dry
completely in the shade before
reattaching them to the vacuum cleaner.
Do not expose the parts to sunlight.
• Do not wash the HEPA lter med water.
• If the primary lter or HEPA lter are
damaged, they must be replaced before
using the vacuum cleaner again,
otherwise the motor can be damaged.
CLEANING OF CLOTH
The cleaning cloth is intended for use on hard
oors such as wood, tiles, marble, and painted
oors.