•
Press the UP/DOWN button to select the different modes of operation Master, Slave, and then press the
ENTER button to confirm your choice.
•
Press the LEFT button repeatedly to exit the menu and save changes.
Select the desired program on the master unit (described in section 3.5).
Use the DMX connectors of the SUNBLAST and an XLR cable to form a chain of units.
SEQUENCE
The unit independently runs through its show. Before you send an automatic program you need to set the
drive as Master/Alone:
•
Press the ENTER button to access the main menu.
•
Press the UP/DOWN button to scroll the menu, select the Stand Alone icon, then press the ENTER
button to enter the next menu.
•
Press the UP/DOWN button to scroll through the menu, select Sequence and press ENTER to confirm
your choice.
•
Press the UP/DOWN button to select the mode of operation: Show 1, Show 2, ..... , Show 18
•
Press the ENTER button to confirm your choice.
•
Press the LEFT button repeatedly to exit the menu and save changes.
The unit will go into automatic mode by executing the program automatically.
To Next Page
Loading...