Dimmer 1 - Light intensity control is finer at low level and coarse at high levels.
Dimmer 2 - Light intensity control is finer at high level and coarse at low levels.
Dimmer 3 - Light intensity control is finer at low and high levels, and coarse to medium levels.
- Temperature - Through the Temperature function can be displayed the temperature inside the fixture,
near the lamp. The temperature can be displayed in degrees Celsius or Fahrenheit.
•
Press the ENTER button to confirm your choice.
•
Press the LEFT button repeatedly to exit the menu and save changes.
3.7
LAMP SETTINGS
Factory Reload
Select this function to reset the unit to factory settings:
•
Press the ENTER button to access the main menu.
•
Press the UP/DOWN button to scroll the menu, select the Advanced icon, then press the ENTER button
to enter the next menu.
•
Press the UP/DOWN button to scroll through the menu, select Factory Reload and press the ENTER button
to enter the next menu.
•
Press the UP/DO WN button to select ON or OFF, then press the ENTER button to confirm.
3.8
FIXTURE INFORMATION
To view all the information on the device, proceed as follows:
•
Press the ENTER button to access the main menu.
•
Press the UP/DOWN button to scroll the menu, select the icon Information, then press the ENTER but-
ton to enter the next menu.
•
Press the UP/DOWN button to scroll through the menu, then select one of the following information
and press the ENTER button to display it.
- Fixture Time - Through the Time Information function you can display the operating time of the
projector.
- Temperature - Through the Temperature function can be displayed the temperature inside the fix-
ture, near the lamp. The temperature can be displayed in degrees Celsius or Fahrenheit.
- Fans Speed - Through the Fans Speed function you can show on display the fan speed present near
the lamp. Velocity is expressed in RPM (revolutions per minute).
- Software Version - Through Software Version function you can display the currently installed software
version.
•
Press the LEFT button repeatedly to exit the menu.
3.9
OPERATIONS IN AUTOMATIC MODE
SLAVE RECEIVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
The Slave unit receives data from the Master unit according to the group which the Slave unit was as-
signed to.
For example, if a slave device is set to Receive Part 1, the Master unit Slave unit will send the automated
Chase Part 1; if set to Receive Part 2, the Chase Part 2 Slave units will receive from the Master.
To set the drive as a slave, proceed as follows:
•
Press the ENTER button to access the main menu.
•
Press the UP/DOWN button to scroll the menu, select the StandAlone icon, then press the ENTER button
to enter the next menu.
•
Press the UP/DOWN button to scroll through the menu, and select Master/Slave, and press ENTER.
To Next Page
Loading...