To Next PageTo Next PageWhy Brighter PIXEL Lighting Equipment fixture does not light up?
Your Brighter Lighting Equipment fixture might not light up due to several reasons: there may be no mains supply, so check the power supply voltage; the dimmer fader or all color faders might be set to 0, so increase the value of the dimmer or color channels; or there may be a faulty LED or LED board, in which case you should replace the LED board.
What to do if Brighter Lighting Equipment fixture does not respond to DMX?
If your Brighter Lighting Equipment fixture isn't responding to DMX, the issue could be due to wrong DMX addressing, so check the control panel and unit addressing. Alternatively, the DMX cables may be damaged, so check them. Finally, bouncing signals can be the cause, so install a terminator as suggested.
How to troubleshoot Brighter PIXEL when it does not power up?
If your Brighter Lighting Equipment fixture doesn't power up, it could be due to a few reasons. First, check for power at the power outlet. Second, inspect the power cord for any looseness or damage. Lastly, a faulty internal power supply could be the culprit, in which case you should replace it.
Why is there a general low light intensity in my Brighter PIXEL Lighting Equipment?
A general low light intensity in your Brighter Lighting Equipment could be caused by a dirty lens assembly, so clean the fixture regularly. Alternatively, the lens assembly might be misaligned, so install it properly.
General| Brand | Brighter |
|---|---|
| Model | PIXEL |
| Category | Lighting Equipment |
| Language | English |
Conforms to European Community Directives and marked with CE. Unit supplied with hazardous voltage, requires skilled personnel for servicing.
Read manual before use. Follow safety regulations. Ensure secure mounting, adequate ventilation, and keep flammable materials away.
Details how to set up the unit on a solid surface or mount upside down, including safety rope usage.
Steps to enter and configure the DMX mode for controlling the fixture.
Guide to setting the DMX start address for effective controller communication and channel assignment.
Step-by-step instructions for safely replacing a blown fuse in the fixture.
