Brinly STS-42BHDK - Page 10

1018189 Rev. C
10
PLACE THIS EDGE ON GROUND.
ASSEMBLY
STEP 5
--------------------------------------------------------
NOTE:
Step 4 is for attaching the Hitch Clevis Assembly (1) to the
Tow Tubes (2). When complete, the Tow Tubes (2) will be
approximately level with the pavement:
a.Usingthispage,setthemanualonthefloorandmeasure
your hitch height as shown in illustration.
b.PositiontheHitchClevisAssembly(1)betweentheTowTubes(2)fortheproper
height.
c.AttachtheHitchClevisAssembly(1)totheTowTubes(2)
asshowninStep4.
d. Attach the sweeper to the tractor.
e. AdjusttheLiftHandle(3)topositionthesweeperbrushestosweepatthesame
height as the mower blades.
f. RechecktheTowTubes(2)forlevel.Thetubesshouldbelevelorslightlyhigherat
sweeper. Readjust clevis if necessary.
g.WhentheproperHitchClevis(1)levelisachieved,securelytightentheLockNuts
(9)installedinStep4.
10”
11”
9”
8”
7”
(top of page)
6”
5”
4”
3”
2”
1”
6”
7”
8”
9”
10”
11”
A
Hitch Plate Height
Measurement
10"
9”
8"
7"
6"
11"
T O P E D GE OF P AGE
BOTT O M E D G E T O GR O UND
Manual
Hitch Clevis Assembly
10"
9"
8"
7"
6"
11"
TOP EDGE OF PAGE
2
PATENT NO. US 6,640,532 B1
Step 5.
NOTE: Step 4 is for attaching the Hitch Clevis Assembly (1)
to the Tow Tubes (2), When complete, the Tow Tubes (2) will
be approximately level with the pavement:
a) Using this page, set the manual on the floor and
measure your hitch height as shown in illustration.
b) Position the Hitch Clevis Assembly (1) between
the Tow Tubes (2) for the proper height.
c) Attach the Hitch Clevis Assembly (1) to the Tow
Tubes (2) as shown in Step 4.
d) Attach the sweeper to the tractor.
e) Adjust the Lift Handle (3) to position the sweeper
brushes to sweep at the same height as the mower
blades.
f) Recheck the Tow Tubes (2) for level. The tubes should
be level or slightly higher at sweeper. Readjust clevis if
necessary.
g) When the proper Hitch Clevis (1) level is achieved,
securely tighten the Lock Nuts (9) installed in Step 4.
3
PATENT NO. US 6,640,532 B1
==================================================================