BRIO Beardscape - Charging Prompts; Caring for your Brio Beardscape

14
Charging Prompts
When only 20 minutes of time remain on the
trimmer, the charging icon will flash and the
Beardscape will make a beep tone, alerting you
to fully charge the Beardscape aer your use.
Caring for your Brio Beardscape
Do not rinse your Beardscape! If you were paying
attention in 6th grade science, you will remember
that oil and water don’t mix. Your blade likes oil, not water. If you
feel there is too much hair or debris on the trimmer, use the includ-
ed brush to clean it off. NEVER run the blade under the water.
You shouldn’t need to remove the blade of your Beardscape very
oen. The internal gears are strong and will not
become clogged with hair. If you do need to remove the blade,
lower the micro-adjust lever all the way down to the 1.9mm setting.
Use two thumbs on the front of the blade and gently press the
blade back. It should pop off easily.
Charge