9
Cleaning and Maintenance
CAUTION: Always ensure the heating, cooling, and ice-making switches are o, and the dispenser
is completely drained of water and unplugged before doing any of the following:
1. Cleaning and Draining – Recommended Before First Use
A. Remove the two screws at the top back of the dispenser (1)�
B. Remove the top cover of the dispenser, then remove the top of the cold water tank (2)�
C. Fill a clean bucket with 0�6 gallons of clean water and pour it into the cold water tank�
D. Place a large bucket beneath the drain outlet at the back of the dispenser� Remove the drain
outlet cover� (3)
3
2
1
E. Plug in the dispenser� Once the Time/Temperature display flashes for 3 seconds, simultaneously
press the up arrow and the hot water button for 3 seconds, dispensing some water from the
water tap� Release up arrow and hot water button�
F. After about 5 minutes, the remaining water will drain from the cold water tank via the drain outlet�
Unplug dispenser� Discard drained water�
G. Reinstall drain cover, cold water tank cover, and top cover of dispenser� Reinstall screws in the
back of the dispenser�
H. Dispenser is ready for installation of first bottle of water�
2. Sanitizing – Recommended Every 3 Months
Use a disinfectant, purchased separately, and follow instructions from manufacturer for use�
3. Removing Mineral Deposits – Recommended Every 6 Months
A. Prepare a solution by mixing 4 liters of water with 200 g of citric acid crystals�
B. Remove top of dispenser, then remove top of cold water tank as shown under “Cleaning and
Draining” on page 8� Pour solution directly into cold water tank�
C. Plug dispenser in and turn on hot water switch�
D. Place a large bucket beneath drain outlet at the back of the dispenser�
To Next Page
Loading...
General