8
Dispense Hot Water
CAUTION: This unit dispenses water at temperatures that can cause severe burns� Avoid direct contact
with hot water� Keep children and pets away from the unit while dispensing� Never allow
children to dispense hot water without proper and direct supervision� To disable the heating
feature, turn the heating switch on the back of the dispenser to the O position�
NOTE: It takes approximately 15 to 20 minutes after plugging in dispenser and turning on heating
switch for water to reach its hottest temperature�
1. The dispenser is equipped with a child-safety feature to prevent inadvertent dispensing of hot water� If
you wish to dispense hot water, first place a cup or container beneath the water dispense point� Press the
lock button to unlock the hot water button, then release� Press and hold the hot water button to dispense
hot water�
2. Release the button when your container is full� Hot water button will automatically lock�
Change the Water Bottle
CAUTION: DO NOT dispense hot or cold water if the change bottle icon is flashing� You could empty the
tanks and cause the dispenser to overheat�
When the change bottle icon begins to blink, it is time to replace your empty water bottle with a new water bottle:
1. Open the dispenser cabinet door and remove the empty bottle�
2. Remove the bottle adapter, letting any remaining water on the tube drip into the bottle� Once dripping
has stopped, place the bottle adapter on the hook and set the empty bottle aside�
3. Follow the steps under “Connect a Water Bottle” on page 5 to install your new water bottle�
4. Recycle the empty bottle at your local exchange center�
To Next Page