2
Safety Information
WARNING: To reduce risk of injury and property damage, you must read this entire guide before assembling,
installing, and operating dispenser�
WARNING: This product dispenses water at very high temperatures� Failure to use properly can cause
personal injury� When operating this dispenser, always exercise basic safety precautions, including
the following:
• Prior to use, this dispenser must be properly assembled and installed in accordance with this
manual�
• This dispenser is intended for water dispensing only� DO NOT use with other liquids or for
purposes for which it was not intended�
• Use only known and microbiologically safe bottled water�
• For indoor use only� Keep water dispenser in a dry place away from direct sunlight� DO NOT use
outdoors�
• Install and use only on a hard, level surface�
• DO NOT place dispenser into an enclosed space or cabinet�
• DO NOT operate dispenser in the presence of explosive fumes�
• Position back and sides of dispenser at least 8 in� (20 cm) from walls to permit free airflow
between wall and dispenser� PLEASE NOTE: For optimal performance, it is recommended the
back and non-fan-outlet side of the dispenser be placed 12 in� (30 cm) from walls, and the fan-
outlet side of the dispenser be placed 19�5 in� (50 cm) from the wall�
• Use with only a properly grounded GFCI outlet�
• DO NOT use an extension cord with your water dispenser�
• Always grasp plug and pull straight out from outlet� Never unplug by pulling on power cord�
• DO NOT use dispenser if cord becomes frayed or otherwise damaged�
• To protect against electric shock, DO NOT immerse cord, plug, or any other part of dispenser in
water or other liquids�
• Ensure dispenser is unplugged prior to cleaning�
• Never allow children to dispense hot water without proper and direct supervision� Children
should be supervised to ensure they do not play with dispenser� Keep the dispenser and its
power cord out of reach of children younger than 8 years old�
• Service should be performed only by a certified technician�
• DO NOT damage the refrigerant circuit�
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard�
• DO NOT immerse dispenser in water or any other liquid�
• The appliance must not be immersed
• ALWAYS keep ventilation openings, in the dispenser enclosure or in the built-in structure, clear
of obstruction�
• DO NOT use mechanical devices or other means to accelerate the defrosting process, other
than those recommended by the manufacturer�
• DO NOT store explosive substances such as aerosol cans with a flammable propellant in this
dispenser�
• This dispenser is not suitable for installation in an area where a water jet could be used�
• Never turn the dispenser upside down or lean it more than 45°�
• The optimal working environment temperature and humidity level for this dispenser is 50 °F-
100�4 °F (10 °C-38 °C) and ≤90% humidity�
To Next Page