How to stop water dripping from Bristan Descent taps?
A short period of dripping after using the taps is normal due to capillary action, where water builds up in the tap body. However, if the dripping continues, it could be due to a build-up of debris or limescale in the ceramic disc valves. In this case, remove the valves and clean them.
Why is there no water or low flow rate from my Bristan Plumbing Product?
There could be several reasons for a lack of water flow or a low flow rate. First, check if the isolation valve is only partially open and fully open it. If you have an instantaneous water heater, the flow rate or pressure may be too low; increase it to meet the tap's minimum working pressure. Also, ensure that the head of water meets the minimum distance requirements. Avoid using other water outlets simultaneously, as this can cause pressure changes. Finally, check for airlocks or blockages in the supply pipework and flush it through to remove any debris or airlocks.
What to do if Bristan Descent Plumbing Product taps do not turn on?
If your Bristan Plumbing Product taps aren't turning on, there are a couple of things to check. First, make sure the isolation valve is open. If it's closed, open it. Second, verify that both water supplies to the tap are turned on. If they're off, turn them on.
Step-by-step instructions for installing basin mixers and 1-hole bath fillers.
Procedure for fitting bath fillers and bath shower mixers, including diverter operation.
Detailed steps for installing the floor-standing bath shower mixer unit.
General| Mounting | Deck Mounted |
|---|---|
| Style | Modern |
| Finish | Chrome |
| Material | Brass |
| Handle Type | Lever |
| Hole Requirement | 1 Hole |
To Next Page