04
5. Installation Cont.
1. Identify all components are present, prior to starting installation.
2. Fit the mixer body to the basin using the ‘C’ plate fixing kit. The plinth
(8) and washer (9) go between the fitting and the basin and the ‘C’
shaped rubber (11) and metal washers (12) on the underside of the basin.
Secure into position using threaded rods (13 )and nuts (14).
3. Fit the inlet connection pipes (15) by hand only (DO NOT OVERTIGHTEN) to the fitting
and connect the hot and cold supplies.
4. If applicable fit the waste (16) using washers below and above the basin
(supplied). It is recommended that a silicone sealant be applied to both
sealing faces of the washers.
5. Fully open the mixer in the mid position, letting it run for a few minutes
allowing time to check all joints and connections for leaks.
6. See page 6 for aftercare instructions.
NOTE: J EBAS C has an innovative water saving feature that
offers a subtle resistance as it reaches approximately half of
its full flow capability. For increased flow, this feature can be
overridden. At full flow the eco click cartridge uses 32% less
water than a standard cartridge and when in eco click mode
the reduction increases to 72%.
To Next Page
Loading...
