EN | 5756 | EN
Portion Sizes
It is possible to preset two different portion sizes for
each water type apart from hot water.
To enter portion setting mode:
1. Enter the menu.
2. Select ‘Portion sizes’
3. Select portion size A or B.
The system will guide through the next steps.
To set a portion size:
4. Set a suitable vessel under the tap outlet.
5. Press the desired water type button.
6. Stop pressing when having dispensed the desired
amount. Make sure not to overll the vessel.
7. Press the ‘conrm’ button to nish setting mode
or press ‘reject’ to delete the set portion.
8. To add more water, press the water icon again.
The setting has to be done separately for every wa-
ter type.
Note: The preset portion may vary depending on
local water supply ow rate. Portion setting is not
available for hot water.
The portion setting can be adjusted:
1. Off: No portion setting available
2. One time: Portion size has to be selected for
every dispense
3. Repetitive: Portion size selected last time stays
activated
It is recommended not to exceed 1 litre per
portion size. The setup is done at operator’s
own risk.
Temperature setting
The cold water temper-
ature can be preset to
three different levels:
Cold
Colder
Coldest
The hot water tempera-
ture can be preset to:
70 °C, 75 °C, 80 °C,
85 °C, 90 °C, 91 °C,
92 °C, 93 °C.
Set water temperature:
1. Enter the menu
2. Select menu ‘Set
temperature’
3. Select desired tem-
perature. The setting
will be saved auto-
matically.
The temperature of the
set water temperature
may vary depending on
local water supply and
environment tempera-
ture.
Only for operator or service technicianSETTINGSMENU STRUCTURE
System Setup
Enter menu Swipe downwards with two ngers on the under-
counter display. PIN code (1966) has to be entered.
Set language Push the language button and turn back to system
setup.
Set boiler standby
• Off: no standby timer set
• Set boiler standby with ˄/˅ arrows in 30 minute
intervals.
• Set boiler temperature with ˄/˅ arrows
Night mode
• Set start and end time of night mode with ˄/˅ ar-
rows in 1 minute intervals.
• Set operate time for weekdays to either off, full or
time based.
• Start/stop night mode.
Set date/ time Set the time with arrow buttons.
Set the date with arrow buttons.
Set brightness
Set the button brightness:
• 0%: min brightness
• 50%: med. brightness
• 100%: max. brightness
Set the display brightness
between 0% and 100% in
steps of 5%.
Set units Choose between the units metrical (°C, liter...) and
empirical (F, gal...).
All settings can only be executed by the operator or the service technician. The
settings will be saved automatically.
To Next Page
