EasyManua.ls Logo

Brita VIVREAU EXTRA Series - Period of Inactivity

Brita VIVREAU EXTRA Series
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN | 6564 | EN
PERIOD OF INACTIVITY
Before the water dispenser is inactive for a period of more than 72 hours, pro-
ceed as follows:
Before a period of inactivity longer than 72 hours
WARNING!
Danger to health due to a lack of hygiene!
Do not disconnect the water dispenser from the power supply.
1.
3.
1. Turn off the water supply.
2. Close the CO
2
bottle valve.
3. Place a note on your dispenser to ensure no one
uses it while the water supply is disconnected.
2.
After an inactive period longer than 24 hours or a power failure, clean the tap,
housing and drip tray with antibacterial wipes and disinfectant spray, reconnect
the water supply and open the
CO
2
bottle valve. Place a vessel on the drip tray
and ush the water dispenser with:
After a longer period of inactivity
Caution! 
the water dispenser with 10 l of unchilled still, 10 l of chilled still,
20 l of sparkling water and 5 l of hot water (Large boiler: 10 l). After a
period of more than four weeks, system sanitization and lter replacement are
necessary. Please contact customer service (see rear page).
WARNING! Danger to health due to a lack of hygiene! Risk of microbi-
al growth whenever your water dispenser is disconnected from its power
supply for more than 120 minutes. If disconnected for longer (but less than
24 hours), restart your dispenser and ush it as explained below (for 4 days’ to
4 weeks’ inactivity). If the dispenser is disconnected for more than 24 hours,
system sanitization and lter replacement are necessary. Please contact cus-
tomer service (see rear page).
1.
2 L
1. 2 l of unchilled
still water
2. 2 l of chilled
still water
2.
8 L
3.
3. 8 l of sparkling
water
4. 2 l of hot water
2 L
4.
2 L