EasyManua.ls Logo

Britax CLICKTIGHT FRONTIER - Securing Your Child; Harness Mode

Britax CLICKTIGHT FRONTIER
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 19
Britax Child Safety, Inc. FRONTIER/PINNACLE CLICKTIGHT User Guide
Securing Your Child
Harness Mode
Never route the vehicle belt over the child when using this
child seat in harness mode�
Adjust the belts provided with this child seat so they fit
snugly around your child� A snug strap should not allow
any slack� It lies in a relatively straight line without sagging�
It does not press on the child’s flesh or push the child’s
body into an unnatural position�
Adjust the harness to fit the clothes the child is wearing�
Remove bulky coats and/or jackets before putting the
child in the child seat�
Verify that the child seat is secure and the harness is
properly adjusted around the child each time the child seat
is used�
Before you begin:
Always check the seat area for debris and remove
it to prevent interference with the harness adjuster
mechanism or CLICKTIGHT
1� Loosen the harness�
a� Press the release lever�
b� Pull both harness
straps forward�
2� Open the chest clip�
a� Press tabs�
b� Pull apart�
3� Release the buckle and
place the harness straps
around the armrests�
Before traveling, verify that the:
9 Harness straps are not twisted�
9 Harness is snug�
9 Buckle is fastened�
9 Chest clip is at the child’s armpit level�
WARNING!
Pull the harness adjuster
away from the child seat
(parallel to the ground) to
tighten.
Do not pull sideways.
4� Place the child in the child
seat� Ensure the child
is positioned upright in
the child seat and not
slouching� Their bottom
must touch the child seat,
and their back must rest
flat against the back of the
child seat�
5� Position the harness straps around the child (see page
22)�
6� Fasten the harness buckle�
Proper connection is
confirmed with a click
after inserting each buckle
tongue�
7� Pull the harness adjuster
strap to tighten the
harness�
NOTE: The harness should
have a snug fit around the
child. A snug strap should
not allow any slack. It lies
in a relatively straight line
without sagging. It does
not press on the child’s
flesh or push the child’s
body into an unnatural
position. You should not be
able to pinch excess webbing.
8� Fasten the chest clip and
place the chest pads
in any position that is
comfortable for the child
within the range of the
correctly placed chest clip�
NOTE: The correct height
for the chest clip is at the
middle of the chest at
armpit level.
a
b

Table of Contents

Related product manuals