Britax CLICKTIGHT FRONTIER - Harness Mode: Lap-Shoulder Belt with CLICKTIGHT

10 11
Britax Child Safety, Inc. FRONTIER/PINNACLE CLICKTIGHT User Guide
Installation in Harness Mode
Lap-Shoulder Belt with CLICKTIGHT (Preferred Method)
Before you begin:
• Check that your vehicle has a top tether anchor�
The top tether MUST be used in harness mode
for children that weigh more than 65 lbs (29�5 kg)�
Britax recommends that the top tether be used at all
times when installing the child seat� Using the top
tether will improve the stability of your child seat and
reduce the risk of injury� Check your vehicle owner’s
manual for tether anchor locations�
• Loosen the tether and place it over the child seat
back to keep it from becoming pinned between the
child seat and vehicle seat during installation�
• Adjust the child seat to desired position and place
forward facing on the vehicle seat�
1� Release the buckle and
open the CLICKTIGHT�
a� Locate the two slots
in the CLICKTIGHT
cover�
b� Squeeze the
CLICKTIGHT release
levers�
2� Pull the vehicle belt out
and route along the green
belt path� Verify that the
belt is not twisted and then
buckle�
3� Remove slack from the lap
part (a), then shoulder part
(b) of the vehicle belt�
IMPORTANT: Only remove
slack from the vehicle
seat belt� Overtightening
the belt may prevent the
CLICKTIGHT from properly
securing�
4� Close the CLICKTIGHT�
A click confirms the
CLICKTIGHT is secure�
NOTE: The child seat is
secure when it cannot be
moved front-to-back or
side-to-side more than 1
in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat the installation
procedure or use a dierent seating location.
9 Check all connections and verify that child seat is
secure� The child seat is secure when it cannot be
moved front-to-back or side-to-side more than 1 in�
(2�5 cm) at the belt path� If the child seat is not secure,
repeat the installation procedure or use a dierent
seating location�
9 Check that any excess tether webbing is contained
within your vehicle and secured in the elastic strap�
5� Firmly press the tether
hook over a designated
vehicle tether anchor�
Remove slack�
6� Secure excess webbing
with the elastic strap�
Harness Mode: Lap-Shoulder Belt with CLICKTIGHT
Or
Or