24 25
Britax Child Safety, Inc.
24 25
FRONTIER/PINNACLE CLICKTIGHT User Guide
2� Open the CLICKTIGHT�
a� Locate the two slots
in the CLICKTIGHT
cover�
b� Squeeze the
CLICKTIGHT release
levers�
3� Unhook the retaining clips
at the back of the seat
cover� Pull the seat cover
forward and over the belly
pad�
4� Turn and pull the buckle
retainer through the slot in
the child seat shell�
Positioning the Buckle
IMPORTANT: Select the slot closest to, but not under the
child�
1� Turn and push the buckle
retainer through the slot in
the child seat shell�
2� Pull the EZ-Buckle
belly pad through the
corresponding slot in the
seat cover� Place the seat
cover back in its original
position and attach the
retaining clips�
3� Close the CLICKTIGHT�
A click confirms the
CLICKTIGHT is secure�
Using the Harness Buckle
To Fasten: Insert one tongue
at a time into the buckle�
NOTE: Proper connection
is confirmed with an audible
click after inserting each
buckle tongue.
To Release: Press the release
button and pull the tongues
from the buckle�
NOTE: Periodically clean
the buckle to ensure proper
operation. See page 42.
Using the Chest Clip
1� Open the chest clip�
a� Press tabs�
b� Pull apart�
2� Push together to fasten�
NOTE: Always position the
chest clip at armpit level.
Using the Recline
IMPORTANT: This child seat must be used in upright
position in booster mode�
This seat may be used in either the upright or recline
position in harness mode�
1� Pull the recline adjustment
handle and adjust the seat
to the desired position (see
page 8)�
a� Ensure that the seat
is locked into the
desired position before
installing in the vehicle�
b� Ensure the top of
the child seat does not rest against the top of the
vehicle seat back while reclining�
c� Pay attention while adjusting the recline to keep
hands clear of any pinch point�
To Next Page
