Britax CLICKTIGHT FRONTIER - Replacing the Cover; Removing the Buckle

40 41
Britax Child Safety, Inc. FRONTIER/PINNACLE CLICKTIGHT User Guide
Replacing the Cover
1� Pull the elastic bands over
the hooks on the bottom of
the child seat shell�
2� Hook the clips at the front
of the seat cover to the
bottom of the child seat
shell�
3� Pull the seat cover forward
and push the EZ-Buckle
belly pad through the
appropriate slot in the seat
cover� Hook the clips at
the back of the seat cover
to the child seat shell�
4� Fit the cover over the
CLICKTIGHT and pull
the elastic band over the
hook on the bottom of the
CLICKTIGHT�
5� Close the CLICKTIGHT�
A click confirms the
CLICKTIGHT is secure�
6� Fit the side wing cover to
the child seat shell and pull
the elastic band over the
hook at the top of the child
seat shell� Repeat for the
other side�
7� Pull the bottom elastic
bands over the hooks at
the bottom of each side of
the head restraint�
8� Fit the head restraint cover
over the head restraint and
pull the top elastic bands
over the hooks at the top
of each side of the head
restraint�
9� Attach the hook and loop
fasteners on the head
restraint cover around the
harness�
Removing the Buckle
IMPORTANT: If your child eats and drinks while in the
child seat, you may need to check the buckle periodically
and rinse out any accumulated debris or dried liquids�
1� Open the CLICKTIGHT�
a� Locate the two slots
in the CLICKTIGHT
cover�
b� Squeeze the
CLICKTIGHT release
levers�
2� Unhook the clips at the
back of the seat cover
from the child seat shell�
NOTE: Pull the belly pad
over the buckle retainer to
remove.
3� Pull the seat cover forward
and over the EZ-Buckle
belly pad�