Need help?Do you have a question about the Brivis UF3 Series and is the answer not in the manual?
Comply with AS 5601 and local gas regulations. Fit a gas cock adjacent to the heater.
Connect to a standard 10 Amp 220-240 Volt switched socket. Use authorized power supplier; avoid generators.
Install heater to allow adequate and safe access for service, adhering to manual and standard guidelines.
Classic BX3 range designed for external installation only. Mount on a level concrete base and ensure water drainage.
Classic 2PWN range for roof or underfloor installation. Must comply with AS 5601 guidelines.
Specifies minimum clearances from the front, ends, and top of the heater for servicing.
Details minimum clearances for flue terminals from walls, ground, and other openings, per AS 5601.
Guidance on thermostat placement to ensure accurate temperature readings, avoiding environmental influences.
Explains the need for an accessory relay loom for Add-On cooling or Fan Only operation.
Procedure to measure and verify the incoming gas supply pressure using a manometer.
Procedure to check burner pressure against the data label and adjust the gas valve regulator.
Adjust fan speed to achieve desired temperature rise at outlets based on floor or ceiling system type.
Final verification of pressures, temperatures, fan operation, leak testing, and customer instruction.
Comply with AS 5601 and local gas regulations. Fit a gas cock adjacent to the heater.
Connect to a standard 10 Amp 220-240 Volt switched socket. Use authorized power supplier; avoid generators.
Install heater to allow adequate and safe access for service, adhering to manual and standard guidelines.
Classic BX3 range designed for external installation only. Mount on a level concrete base and ensure water drainage.
Classic 2PWN range for roof or underfloor installation. Must comply with AS 5601 guidelines.
Specifies minimum clearances from the front, ends, and top of the heater for servicing.
Details minimum clearances for flue terminals from walls, ground, and other openings, per AS 5601.
Guidance on thermostat placement to ensure accurate temperature readings, avoiding environmental influences.
Explains the need for an accessory relay loom for Add-On cooling or Fan Only operation.
Procedure to measure and verify the incoming gas supply pressure using a manometer.
Procedure to check burner pressure against the data label and adjust the gas valve regulator.
Adjust fan speed to achieve desired temperature rise at outlets based on floor or ceiling system type.
Final verification of pressures, temperatures, fan operation, leak testing, and customer instruction.
General| Brand | Brivis |
|---|---|
| Model | UF3 Series |
| Category | Gas Heater |
| Language | English |
To Next Page
