To Next PageTo Next Page
Need help?Do you have a question about the BRKT ARM3780HD and is the answer not in the manual?
Connect the universal monitor plate to a flat back panel using the specified hardware.
Connect the universal monitor plate to a curved back panel using the specified hardware.
Ensure the monitor plate is horizontally centered on the back of the flat panel.
Attach vertical rails to the monitor plate's horizontal rod using pre-installed screws.
Find wall studs and mark their edges and center locations for pilot holes.
Use the template to mark the wall for pilot holes, ensuring proper alignment with a level.
Drill pilot holes and securely mount the wall plate and arm assembly to the wall studs.
Identify solid concrete, select the correct drill bit, and prepare to drill pilot holes.
Mark pilot hole locations on concrete walls using a template and drill the holes.
Insert wall anchors and secure lag bolts to mount the wall plate and arm assembly.
Attach the universal mount bracket to the arm assembly and wall bracket; assistance may be required.
Secure the acorn nut and washer onto the monitor plate and arm assembly using the provided hardware.
Use the ratchet handle lever to adjust the tilt mechanism tension for desired panel tilt.
Utilize the built-in level and adjust acorn nuts for precise post-installation tilt correction.
General| Category | Racks & Stands |
|---|---|
| Material | Steel |
| Color | Black |
| Cable Management | Yes |
| Adjustable | Yes |
| Type | Wall Mount |
| Tilt Range | -5° to +15° |
| Swivel Range | ±45° |
| Mounting Interface | Wall |
