Brocade Communications Systems FastIron SX Series User Manual

This example shows that the running conguration contains six route maps. Notice that the match and set statements within each route
map are listed beneath the command for the route map itself. In this simplied example, each route map contains only one match or set
statement.
To display the active conguration for a specic route map, enter a command such as the following, which species a route map name.
device# show route-map setcomm
route-map setcomm permit 1
set community 1234:2345 no-export
This example shows the active conguration for a route map named "setcomm".
Syntax: show route-map [ map-name ]
Displaying BGP4 graceful restart neighbor information
To display BGP4 restart information for BGP4 neighbors, enter the show ip bgp neighbors command.
device# show ip bgp neighbors
Total number of BGP Neighbors: 6
1 IP Address: 10.50.50.10, AS: 20 (EBGP), RouterID: 10.10.10.20, VRF: default
State: ESTABLISHED, Time: 0h0m18s, KeepAliveTime: 60, HoldTime: 180
KeepAliveTimer Expire in 34 seconds, HoldTimer Expire in 163 seconds
Minimum Route Advertisement Interval: 0 seconds
RefreshCapability: Received
GracefulRestartCapability: Received
Restart Time 120 sec, Restart bit 0
afi/safi 1/1, Forwarding bit 0
GracefulRestartCapability: Sent
Restart Time 120 sec, Restart bit 0
afi/safi 1/1, Forwarding bit 1
Messages: Open Update KeepAlive Notification Refresh-Req
....
Displaying AS4 details
This section describes the use of the following show commands, which produce output that includes information about AS4s.
• show ip bgp neighbor shows whether the AS4 capability is enabled.
• show ip bgp attribute-entries shows AS4 path values.
• show ip bgp shows the route entries with two and AS4 path information.
• show route-map shows the presence of any AS4
conguration data.
• show ip as-path-access-lists shows the presence of any AS4 conguration data.
• show ip bgp cong shows the presence of any AS4 conguration data.
Route entries with four-byte path information
The show ip bgp command without of any optional parameters display AS4 path information.
device# show ip bgp
Total number of BGP Routes: 1
Status codes: s suppressed, d damped, h history, * valid, > best, i internal, S
stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*> 10.1.1.0/24 192.168.1.5 1 100 0 90000 100 200 65535
Displaying BGP4 information
FastIron Ethernet Switch Layer 3 Routing
462 53-1003627-04

Brocade Communications Systems FastIron SX Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron SX Series
Category	Switch
Language	English