Brocade Communications Systems ICX 7450 series Software Update

Summary of Enhancements in FastIron Release 08.0.30 (Continued)TABLE 1
Feature Description Location
Layer 3 unicast routing over MCT This feature is introduced on the ICX
7750.
sflow CLI changes
Several sflow source commands
are introduced.
Upgrading to or downgrading from
FastIron 08.0.30 on page 11
Stacking CLI changes Stacking CLI changes are introduced
to support removable modules on
the ICX 7450.
Upgrading to or downgrading from
FastIron 08.0.30 on page 11
Stacking flash file changes The stacking.boot file changes
format in this release.
Upgrading to or downgrading from
FastIron 08.0.30 on page 11
Unicast Reverse Path Forwarding
(uRPF) check
This feature is introduced. Upgrading to or downgrading from
FastIron 08.0.30 on page 11
Supported hardware
This guide supports the following product families from Brocade:
• FastIron X Series devices (chassis models):
‐ FastIron SX 800
‐ FastIron SX 1600
• Brocade FCX Series (FCX) Switch
• Brocade ICX
™
6610 (ICX 6610) Switch
• Brocade ICX 6430 Series (ICX 6430)
• Brocade ICX 6450 Series (ICX 6450)
• Brocade ICX 6650 series (ICX 6650)
• Brocade ICX 7250 series (ICX 7250)
• Brocade ICX 7450 series (ICX 7450)
• Brocade ICX 7750 series (ICX 7750)
For information about the specific models and modules supported in a product family, refer to the
hardware installation guide for that product family.
NOTE
The Brocade ICX 6430-C switch supports the same feature set as the Brocade ICX 6430 switch
unless otherwise noted.
NOTE
The Brocade ICX 6450-C switch supports the same feature set as the Brocade ICX 6450 switch
unless otherwise noted.
Supported hardware
10 FastIron Ethernet Switch Software Upgrade Guide
53-1003632-02

Brocade Communications Systems ICX 7450 series Specifications

General

Brand	Brocade Communications Systems
Model	ICX 7450 series
Category	Switch
Language	English