Site Manual
Alarm 2000 Iss 5
44
9. System conditions remotely monitored
Smoke / Heat Alarm activation
Sprinkler activation
Monitored valve tamper
System fault
System ‘OFF’
Control panel enclosure tamper
Power supply fault
Power supply fail
Emergency lighting activation
Heating/cooling shutdown activation
Other (see attachment)
10. Are the Smoke / Heat Alarms interconnected?
Yes No
11. Is the interconnect wire rated for LV and segregated from the 230 Volt supply lines?
Yes No
12. Does the 230 Volt power to the smoke/heat alarms originate from the control panel?
Yes No
13. Are the Smoke / Heat Alarms wired for the isolate function (4 wires)
Yes No
14. Does the 230 Volt power to the ancillary equipment originate from the control panel?
Yes No
15. Are all protective and segregation shrouds fitted correctly?
Yes No
16. Have all cable terminations been checked against the appropriate wiring diagram to ensure
correct location and polarity, giving particular attention to Active/neutral and battery
connections?
Yes No
To Next Page
Loading...
