BROOKS AUSTRALIA RFP6 Installer ISSUE 4
24
Step 7. If there is a device connected to the defect mode output, check that
the device is activated when:
* Power is switched “off”
* Ancillary Isolate Switch is “on”
* Following procedure in step 6 and fault LED is illuminated
Step 8. Return the panel to its normal operating condition and reset any
latching indicators by switching the key switch to the “Off” position
and then back to the “On” position.
Note: If latching ancillary devices are used these will need to be
individually reset.
If system has been customised the functions selected may require
additional testing.
If during testing any of the above steps fail, refer to the “Trouble Shooting” section 6
in this book. If you are unsure of any test results please do not hesitate to contact
Brooks Australia on 1300 65 8000.
To Next Page
Loading...
