CHARGING THE BATTERY
Charge the battery before first use. A full charge takes approximately
1.5 hours. After charging, the device can be used without the power
connection. When the battery is low, the LED indicator flashes red once
per minute.
If the device is not used for an extended period of time, the battery may
require recharging.
To charge the battery:
1. Plug the USB connector into a USB port on an active device.
2. Plug the Micro USB end of the USB connector into the Micro USB
port on the earbuds. The LED light turns red during charging. The light
turns blue when the earbuds are fully charged.
6 7
PAIRING WITH BLUETOOTH
®
1. Prepare your device (e.g., smartphone) to pair using Bluetooth
®
,
making sure that the device is within 33 feet of the earbuds. Refer to
your device's owner’s manual for information on using the Bluetooth
®
function.
2. Press and hold the earbud's Multi-Function Button (MFB)for about 4
seconds, until the LED alternates between red and blue, indicating that
the earbuds are in pairing mode.
3. On your device, search the list of available devices and select Big Blue
Color Earbuds. Note that it may take a few seconds for the earbuds
to be listed as an available device. Depending on your device, you
may have to tap SCAN to update the device list. Consult your device's
owner's manual.
4. If prompted, type the password or PIN 0000.
A message will display on your device confirming that your device is now
paired/connected and the earbud's LED will flash blue three times quickly,
indicating that the device is paired.
The devices will remain paired, even after being turned off, until you cancel
the pairing. Consult your device's owner's manual for information on
cancelling pairing.
The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any
use of such marks by Brookstone is under license.
To Next Page
Loading...
