8
CONTROLLER
9
SYNCHRONIZE THE DRONE WITH THE CONTROLLER
1. Ensure that the battery has been fully charged (see Page 7).
2. Insert the battery into the battery compartment on the underside of the drone and
plug the battery's charging terminal into the drone.
3. Place the drone on a flat surface.
4. Press the controller's left control stick downward.
5. Slide the controller's ON/OFF switch to the ON position.
6. Very slowly, move the left control stick to its upper limit. You will hear a tone.
7. Move the left control stick down slowly. When the left control stick returns to its
starting position in the lower section, you will hear another tone and the LED lights
stop flashing. The controller and drone are now synchronized.
SET YOUR SPEED
The drone has three speed settings. While learning to use the drone, it is advisable to
start by using the slowest speed setting.
To check and change the speed, press the Speed Selector on the controller.
• If you hear two tones, the drone is in slow speed.
• If you hear three tones the drone is in intermediate speed.
• If you hear a continuous series of tone the drone is in fast speed.
1. Speed Selector
2. Power LED
3. Left Control Stick
4. Left/Right Rotate Trim
5. Return Home Button
6. Headless Mode Button
7. Forward/Backward Trim
8. Left/Right Trim
9. Right Control Stick
10. Camera LED
11. Camera Button
12. Smartphone Holder
3
2
1
12
11
10
9
54 6
3
87
To Next Page
Loading...