ASSEMBLING THE OBSTACLES
The obstacles are pre-cut on three foam core boards.
Before assembling, remove each piece and pop out the foam from the pre-cut slots.
14 15
To assemble the landing pad:
1. Align the tabs in Part 1 (4 pieces) with the slots in the bottom of Part 2 and push to
attach.
To assemble the stunt ring:
1. Bend the ends of Part 5 along the pre-creased lines.
2. Align the slots in Part 5 with the slots in Part 3 and push to attach.
To assemble the course flag:
1. Align the slot on Part 4 with the slot on the bottom of Part 6 and push to attach.
2. Align the slots in Part 7 with the tabs in the combined Part 4 and Part 6 and push
to attach.
6 3 2 5
4
1 7
To Next Page
Loading...
