6. USING THE OPERATION PANEL (BASIC OPERATIONS)
31
BAS-342G
6-7. Setting the height of the intermittent presser foot
You can use the operation panel to change the setting value for the intermittent presser foot height.
1
THREAD/CLAMP indicator illuminates
MENU indicator switches off
Press the THREAD/CLAMP key.
The sewing machine will switch to threading mode.
• " 1" will appear in the PROGRAM No. display and the
intermittent presser foot (1) will drop.
2
Press the key.
The sewing machine will switch to intermittent presser foot height
setting mode.
• " 4" will appear in the PROGRAM No. display and the
intermittent presser foot (1) will rise to the setting value that
appears in the menu display.
(Intermittent presser foot height setting: 0.0 − 10.0)
Press the or key to set the intermittent presser foot
height.
• The intermittent presser foot (1) will be raised or lowered to the
height of the new value that has been set.
NOTE:
After making the setting, be sure to turn the pulley once by
hand and check that the intermittent presser foot (1) does not
touch the needle bar.
<Changing modes>
" 1" Threading mode
↑ ↓
" 4" Intermittent presser foot height setting mode
3
Ending setting mode
THREAD/CLAMP indicator switches off
Press the THREAD/CLAMP key.
• The setting values will be memorized.
• The intermittent presser foot (1) will return to the status that it
was at before the sewing machine was switched to setting
mode.
Intermittent presser foot operation
1 Intermittent presser foot lift amount
2 Intermittent presser foot height
The settings can be made by the above
operations.
However, if the intermittent presser foot
height is set to a smaller setting than the
intermittent presser foot stroke, the
intermittent presser foot will not drop in
order to prevent it from coming into contact
with the needle plate.
3 Intermittent stroke
When making the adjustment, refer to
"11-13. Changing the intermittent stroke" in
the instruction manual CD.
All indicators switch off
5225Q
5033Q
During standby
When lowered
While sewing
4445Q
2576B
4016M
To Next Page
Loading...
