Brother BAS-411 - 3 Lubrication

•
[!I Installing guard bar
-
-
I
I
~
®
&
[§] Setting up machine
•
Attach the screws 0 so that the panel is in the best position for the
operator to use.
1) Loosen the screws, and covers RD 0 and LD@.
2) Insert the guard bar @ and attach it with the bolt and washer
from the bottom side ofthe frame.
3) Install covers RD 0 and LD@ with the screws.
Before shipping,
the machine is set as shown in the figure on the
left.
Turn the clutch knurl 0 until its red mark @ is on the needle bar
case side. The machine will be in the automatic jump condition.
This is the standard condition of the machine.
[NOTE] Refer
to the note on P.32 "[!] Preparation of machine (1)."
-4-
From the library of: Superior Sewing Machine & Supply LLC