Brother BAS-416A

To Next Page

To Previous Page

Main Page

Safety Instructions3
Safety Indications and Their Meanings3
Warning Labels6
Contents8
An Introduction of Embroidery Machine11
Explanation of Models11
Specifications12
Preparation of Embroidery Machine13
Names of Machine Components13
Installation14
Transportation of Machines14
Installation of Machines14
Installation Operation Panel15
Installing Guard Bar15
Preparation of Machine16
Power16
Confirm the Following before Switching on the Machine16
When Turning on the Power of the Machine17
If the Following Are Displayed17
If Carriages X and y Operate Unusually (Clearing and Resetting Memory)19
Preparation for Embroidering20
Replacing Bobbin20
Replacing and Selecting Needle20
Upper Threading21
Thread Tension23
Needle Thread Tension23
Adjusting the Spring23
Bobbin Thread Tension23
Attaching Embroidery Hoop to Holder Base24
Attaching Tubular Square Hoop to Holder Base25
Attaching Sashes Frame Set26
Operation of Machine28
Default Sewing of Patterns28
Repeat Sewing31
Keys Available in the Sewing Mode34
Restarting36
Embroidering Procedures38
Flow Chart38
Inserting Floppy Disk39
Names40
Functions of Keys on Operation Panel41
LED Lamp45
Operation Panel Display46
Dip Switch Functions47
Dip Switch Functions on Main Printed Circuit Board47
Dip Switch Functions on Operation Panel48
Entering Embroidery Date49
Summary of Main Menu50
Entering Floppy Disk Data51
Error Messages52
Area over53
There Is a Thread Breakage54
Keys Available During Floppy Data Entry55
Entering Data from Paper Tape56
Error Messages When Receiving Data from Paper Tape Reader57
Keys Available During Inputting Floppy Data58
Entering Data from BAS-PC/EM System59
Error Messages When Receiving Data from BAS-PC/EM System60
Keys Available During Reding Data from BAS-PC/EM System62
Editing Embroidery Data63
Editing Method63
Checking Editing Information64
Keys Available in the Editing Menu65
Editing Function66
Rotating66
Setting Mirror Image67
Setting Repeat Sewing68
Keys Available in the Setting Repeat Sewing69
Sewing Function70
Explanation of Sewing Function70
Setting Hoop Feed Point71
Needle Bar Setting73
Selecting Needle Bar75
Setting Bobbin Thread Counter and Thread Breakage Sensor76
Function of Speed Volume Table Setting78
The Relation between SW and Volume Table79
The Relation between Volume Table No. and Display79
Function of Speed Setting for Test Feed80
Function of Sewing Area Selection81
Function of Setting Feed Volume of Thread Pulling at Time of Thread Trimming86
Skip Function of 0 MM Stitch87
Function to Select Alarm at Time of Thread Breakage88
Sensitivity Switching Function for the Thread Breakage Sensor89
Thread Trimmer Operation Activation/Deactivation Setting Function90
Mask Check Activation/Deactivation Setting Function91
Connection and Installation of Optional Equipment92
Tape Reader92
Connecting Cable with Machine92
Connecting the Cable with the Paper Tape Reader93
Operating and Preparing Paper Tape Reader93
Notes for Paper Tape Reader94
Bobbin Winder (Option)96
Attaching Bobbin Winder96
Winding Bobbin Thread97
Maintenance98
Cleaning98
Oiling99
Standard Adjustment101
Adjusting Needle Bar Height101
When Using the Bottom Dead Center Gauge103
Adjustment of Timing between Needle and Rotary Hook105
Adjustment of Presser Foot Height105
Adjusting the Belt Tension106
Troubleshooting110

Brother BAS-416A - Page 2

Table of Contents

Other manuals for Brother BAS-416A

Related product manuals