Brother DCP-135C - Connecting the Power Cord; Choosing Your Language

Setting Up the Machine
6
STEP 1
8 While holding the paper tray in place, pull out
the paper support until it clicks, and then
unfold the paper support flap .
Note
Do not use the paper support flap for Legal size
paper.
3 Connecting the power cord
1 Connect the power cord.
Improper Setup
DO NOT connect the interface cable.
Connecting the interface cable is done during
the software installation process.
Warning
The machine must be fitted with an earthed plug.
Note
The control panel warning LED will stay on until
you have installed the ink cartridges.
4 Choosing your language
1 After connecting the power cord, the LCD
shows:
Select Language
q
Press OK Key
Press OK.
2 Press a or b to choose your language and
press OK.
English e
q
Select ab &OK
3 If your language is chosen, press a (Yes).
English?
q
a.Yes b.No
If you set the wrong language, you can
change the language after setting the date
and time. (For details, see Changing LCD
language in Appendix B of the User’s Guide.)