Setting Up the Machine
6
STEP 1
8 While holding the paper tray in place, pull out
the paper support until it clicks, and then
unfold the paper support flap .
Note
Do not use the paper support flap for Legal size
paper.
Note
You can use the photo bypass tray which is
located on the top of the paper tray to print on
photo 4×6 in. (10×15 cm) and photo L size paper.
For details, see Loading photo paper in Chapter 2
of the User’s Guide.
3 Connecting the power cord
1 Connect the power cord.
Improper Setup
DO NOT connect the interface cable.
Connecting the interface cable is done during
the software installation process.
Note
The control panel warning LED will stay on until
you have installed the ink cartridges.
4 Installing the ink cartridges
Warning
If ink gets in your eyes, wash them out with water
at once, and if irritation occurs consult a doctor.
1 Make sure that the power is turned on.
The LCD shows:
No Cartridge
Black
Yellow
Cyan
Magenta
2 Open the ink cartridge cover (1).
3 Pull all the lock release levers down and
remove the yellow protective part (1).
Note
Do not throw away the yellow protective part. You
will need it if you transport the machine.
1
1
To Next Page
Loading...
