5
h
Gently push the ink cartridge until it clicks. After
all the ink cartridges are installed close the ink
cartridge cover.
6
Check the print quality
a When the preparation process has finished, the
LCD shows this message
Set Paper and
q
Press Start
Press Colour Start.
b Check the quality of the four colour blocks a
on the sheet. (black/yellow/cyan/magenta)
c If all lines are clear and visible, press a (Yes) to
finish the quality check and go to step 7.
If you can see missing short lines, press b (No)
and go to d.
d The LCD asks you if the print quality is OK for
black and colour. Press a (Yes) or b (No).
Black OK?
q
a Yes b No
.
Color OK?
q
a Yes b No
After pressing a (Yes) or b (No) for both black
and colour, the LCD shows:
Start Cleaning?
q
a Yes b No
e Press a (Yes), the machine will then start
cleaning the colours.
f After cleaning is finished, press Colour Start.
The machine starts printing the Print Quality
Check Sheet again. Go back to b.
Note
The machine will prepare the ink tube system for
printing. This process will take approximately four
minutes. Do not turn off the machine.
1
OK
Poor
To Next Page
Loading...
Need help?
General
