Brother DCP-6690CW - Page 40

Configuring your machine for a wireless network (Not available for MFC-5490CN and MFC-5890CN)
30
3
m Choose and press the key option KEY1, KEY2, KEY3, KEY4.
If you chose the key which shows **********, go to n.
If you chose a blank key, go to o.
n If you want to change the key you chose in m, press Change. Go to o.
If you want to keep the key you chose in m, press Keep. Go to r.
o Enter a new WEP key. Press OK. Go to r. (For information how to type text, see Entering Text
on page 161.)
p Choose and press the Encryption type, TKIP or AES. Go to q.
q Enter the password and press OK. Go to r. (For information how to type text, see Entering Text
on page 161.)
r To apply the settings, press Yes. To cancel, press No.
If you chose Yes, go to s.
If you chose No, go back to g.
s The machine starts to connect to the wireless device you have chosen.
t If your wireless device is connected successfully, the display shows Connected for 60 seconds and
configuration is completed.
If the connection failed, the display shows Connection Failed for 60 seconds. (See Wireless
network troubleshooting on page 145.)
u Press .
(For Windows
®
)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Install MFL-Pro Suite or
Initial Installation / Install MFL-Pro Suite from the CD-ROM menu.
(For Macintosh
®
)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Start Here OSX from the
CD-ROM menu.