Brother DCP-6690CW - Page 92

Control panel setup
82
6
Note
For DCP models, press a or b repeatedly to enter the first three-digit number for the Gateway address.
Press c to enter the second three-digit number. Repeat this step until you have entered the fourth three-
digit number to complete the Gateway address. Press OK.
g Press Stop/Exit.
For MFC-5490CN
6
a Press Menu, 5, 1, 4.
b Select 1 to change. Enter the Gateway address.
Press OK.
c Press Stop/Exit.
For Touchscreen models 6
a Press MENU.
b Press Network.
c (For Wired) Press Wired LAN.
(For Wireless) Press WLAN.
d Press TCP/IP.
e Press a or b to display Gateway and then press Gateway.
f Enter the Gateway address.
Press OK.
g Press Stop/Exit.
Node Name 6
You can register the machine name on the Network. This name is often referred to as a NetBIOS name; it will
be the name that is registered by the WINS server on your network. Brother recommends the name
BRNxxxxxxxxxxxx for a wired network or BRWxxxxxxxxxxxx for a wireless network (where xxxxxxxxxxxx is
your machine’s Ethernet address) (up to 15 characters).
a Press Menu.
b Press a or b to choose Network.
Press OK.
c (For Wired) Press a or b to choose Wired LAN.
(For Wireless) Press a or b to choose WLAN.
Press OK.