Brother DCP-6690CW - Page 93

Control panel setup
83
6
d Press a or b to choose TCP/IP.
Press OK.
e Press a or b to choose Node Name.
Press OK.
f Enter the Node Name.
Press OK.
Note
DCP models cannot change the Node Name from the control panel menu.
g Press Stop/Exit.
For MFC-5490CN
6
a Press Menu, 5, 1, 5.
b Select 1 to change. Enter the Node Name.
Press OK.
c Press Stop/Exit.
For Touchscreen models 6
a Press MENU.
b Press Network.
c (For Wired) Press Wired LAN.
(For Wireless) Press WLAN.
d Press TCP/IP.
e Press a or b to display Node Name and then press Node Name.
f Enter the Node Name.
Press OK.
Note
DCP models cannot change the Node Name from the control panel menu.
g Press Stop/Exit.