Unpack the machine and check the components
Drum Unit Toner Cartridge
AC Power Cord Quick Setup Guide Product Safety Guide
1
Remove the packing materials and install the toner cartridge and drum unit assembly
2
Load paper in the paper tray
3
Connect the power cord and turn the machine on
Back Front
NOTE:
Before connecting the power cord, locate the Serial Number label on the back or side of
the machine. Record this number for product registration and warranty support.
NOTE:
•The components included in the box may differ depending on your country.
•The available connection interfaces vary depending on the model.
If you use a wired connection, you must purchase the correct cable for the
interface you want to use.
•USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than
2 metres long.
•Network cable (for wired network models only)
Use a straight-through Category 5 (or greater) twisted-pair cable.
•The screens and images in this Quick Setup Guide show the MFC-B7810DW.
•Brother aims to reduce waste and save both raw materials and the energy
required to produce them.
Read more about our environmental work at www.brotherearth.com.
•Save all packing materials and the box in case you must ship your machine.
Remove the orange part.
Push firmly.
Do not exceed this mark.
4
Select your country/language
(Initial setup only)
After turning the machine on, you may be required
to set your country or language (depending on your
machine).
If required, follow the on-screen instructions.
Remove the protective tape or film covering the machine and the supplies.
1
2
Adjust the paper
guides.
Quick Setup Guide
Read the Product Safety Guidefirst,thenreadthisQuick Setup Guide for the correct installation procedure.
Not all models are available in all countries.
The latest manuals are available at the Brother support website:
support.brother.com/manuals
DCP-B7600D / DCP-B7620DW / MFC-B7800DN / MFC-B7810DW
D02V8E001-00
UK
Version 0
To Next Page
Need help?
General