Brother DCP-J140W

20
For Wireless Network Users
i Enter the Network Key you wrote down in
step 11-a on page 16 and click Next.
j Click Next. The settings will be sent to your
machine.
k Disconnect the USB cable between the
computer and the machine.
l Click Next to continue to install MFL-Pro Suite.
Wireless setup is now complete.
To install MFL-Pro Suite, continue to
step 14-e on page 26.
Now go to
Page 26
Note
If your network is not configured for
Authentication and Encryption, the following
screen will appear. To continue configuration,
click OK and go to j.
Note
• The settings will remain unchanged if you click
Cancel.
• If you want to manually enter the IP address
settings of your machine, click Change IP
Address and enter the necessary IP address
settings for your network.
• If the wireless setup failure screen appears,
click Retry and try starting from step h again.