Home > Paper Handling > Load Paper > Load Paper in the Paper Tray > Load Envelopes in the Paper
Tray
Load Envelopes in the Paper Tray
• If the [Check Paper] setting is set to [On] and you pull the paper tray out of the machine, a message
appears on the LCD, allowing you to change the paper size and paper type.
• You can load envelopes in a variety of sizes. See Related Information: Paper Type and Paper Size for
Each Operation.
• When you load envelopes in the tray, you must change the Paper Size setting in the machine or the paper
size setting on your computer.
• Before loading envelopes in the tray, press the corners and sides of the envelopes to make them as flat as
possible.
1. If the paper support flap (1) is open, close it, and then close the paper support (2).
2. Pull the paper tray completely out of the machine.
3. Lift the output paper tray cover (1).
32
To Next Page
Loading...
