2-13
Confidential
First Line Status
Error
Code
Reference
Image too Long
The image cannot be corrected because it is
too large.
Section
4.7.5
Image too Short
The image cannot be trimmed because it is
too small.
Section
4.7.5
Ink Absorber Full
/Ink Box Full
The purge count or flushing count reached
the upper threshold.
46 2-31
Install Starter Ink
A cartridge without the necessary ink volume
for initialization was loaded during
initialization.
24 2-20
Low Temperature
The Casing internal thermistor detected that
the room temperature is too low.
No Caller ID
There is no Caller ID information.
Section
4.9.3
No Ink Cartridge
No Ink cartridge loaded.
2A, 2B,
2C, 2D
2-22
No Paper Fed
The Registration sensor detected that there
is no recording paper in Paper tray.
Section
4.2.1
No Response/Busy
The receiver is busy or there was no
response.
Section
4.9.3
Out of Fax Memory
The amount of accumulated data in the
memory through Memory Receive exceeded
the limit.
Section
4.10.2
Out of Memory
There is not enough memory.
Section
4.10.2
Paper Jam
The Registration sensor, Paper width sensor,
and CR encoder sensor detected a paper
jam.
31, 38,
3C, 82,
84, 8A,
8C
2-25,
2-26,
2-27,
2-37,
2-38,
2-39
Touchscreen Init.
Failed
After the power was turned on, the screen
was touched before Touch panel initialization
could be completed.
ED 2-44
Unable to Print
Some problem occurred during printing.
Take
action
according
to the
displayed
error
code.
To Next Page
Loading...
