Home > Scan > Scan Using the Scan Button on Your Machine > Scan Photos and Graphics
Scan Photos and Graphics
Send scanned photos or graphics directly to your computer.
Use the Scan button on the machine to make temporary changes to the scan settings. To make permanent
changes, use Brother iPrint&Scan.
>> DCP-T520W/DCP-T525W/DCP-T720DW/DCP-T725DW/DCP-T820DW/DCP-T825DW
>> MFC-T920DW/MFC-T925DW
DCP-T520W/DCP-T525W/DCP-T720DW/DCP-T725DW/DCP-T820DW/DCP-T825DW
1. Load your document.
2. Press (SCAN).
3. Press a or b to select the [Scan to PC] option, and then press OK.
4. Press a or b to select the [Image] option, and then press OK.
5. If the machine is connected to a network, press a or b to select the computer where you want to send data,
and then press OK.
If the LCD prompts you to enter a PIN, use the control panel to enter the four-digit PIN for the computer,
and then press OK.
6. Do one of the following:
• To change the settings, press Copy / Scan Options, and then go to the next step.
• To use the default settings, press Mono Start or Colour Start.
- [Colour Setting] depends on the default settings. Pressing Mono Start or Colour Start does not
allow you to change the settings.
- To use scan options, you must connect a computer with Brother iPrint&Scan installed to the machine.
7. The machine will prompt you to set each of the following scan settings. Press a or b to select the desired
option, and then press OK to proceed to the next scan setting.
• [Colour Setting]
• [Resolution]
• [File Type]
• [Document Size]
• [Remove Bkg Clr]
8. Press Mono Start or Colour Start.
97
To Next Page
Loading...
